Following the prompts on the command line to Select next
point, define a polywire on the drawing. This will include the top line
segments on both sides of the polywire. When you have completed this part of
the polywire press
<Enter> or click the right mouse button.
You will be prompted define the Offset to first line
segment. Click on a point below the top line segment on the left side to
define the spacing between line segments on the left side.
You will be prompted define the Offset to last line
segment. Click on a point below the top line segment on the right side to
define the spacing between line segments on the right side. In other words, you
can have different line spacing on the left and right sides of the
multi-polywire.
You will be prompted to Mark position of last line. On
the left side, click on a point just below where you want the last line segment
to begin. The software will draw as many line segments on the left as it can,
based on the spacing and the last line position you selected. It will draw an
equal number of line segments on the right.
